Wednesday, August 10, 2016

50W-65W Car Audio Amplifier Circuit using TDA1562 IC

Robometricschool. - To complete your information about the amplifier for audio car, here we will give you one electronic wiring diagram of 50W-65W car audio amplifier based on or using TDA1562 IC like in Figure below.


Component Part

TDA1562 IC
Resistors
Capacitors
LED
Speaker

Description

The watt power this size suitable for install in our cars, since enough for speakers per channel and cheap. The quality was better than expected. Suitable for installation on all vehicles, Or if to build a power amps to listen to at home,was no problems whatsoever can be applications fully.

From the wiring diagram like in Figure 1 above show us that the 50W BCL car audio amplifiers circuit, at pin 9 and pin 10 of IC1 into the power supply from the battery 12 volts. Then pin 6, 12 and 17 are connected to a negative voltage, there are two capacitors C6, C7 serves as eliminate interference and power backup for IC1, respectively. To make It run without distortion of the noise signal.


0 comments:

Post a Comment

Thank's for your visiting and reading this article, please share your idea with comment here